Plenty of garages in Clarington are workshops first and parking second. Dust, sawdust and frequent openings are hard on rollers and photo-eyes, so we fit sealed bearings, protect the sensors, and set the opener for the extra cycles, so the door keeps pace with whatever you are building inside. Calls from Leskard are covered too.
Garage door services
From a stuck door on a winter morning to a planned replacement before the house goes on the market, the services on this page cover what garage doors in Clarington typically need. Each one explains what is checked, how the work is done and what you can expect afterwards.
Clarington
Garage Door Bottom Seal ReplacementThe gap under the door is a finger wide at one end and nothing at the other.
Garage Door Manual Lock RepairThe T-shaped handle on the outside turns a full quarter, exactly as it has for twenty years, but nothing moves behind it.
Garage Door Cable ReplacementThere was a sharp crack from the garage, and when you went to look the door had dropped on one side and jammed.
Torsion Spring ReplacementThe door starts to rise, gets about the height of your knee, then shudders and reverses.
Garage Door Balance AdjustmentSomeone replaced the springs a while back and the door has bounced at the top ever since.
Chain-Drive Opener RepairHalfway up, the door lurches.
Belt-Drive Opener RepairIt is minus twenty in the detached garage and the door climbs in jerks, the belt stiff as a board.
Photo-Eye Sensor Alignment or ReplacementSomeone backed the car in a little too far, a bin or a bicycle brushed the track, and since then the door starts to close and…
Insulated Steel Garage Door InstallationA refreshed exterior has made the faded garage door stand out.
New-Construction Garage Door InstallationThis garage will be heated and used beyond parking, so the opening needs more than a basic closure.New Doors
The right door for this climate has insulated sections, seals that stay flexible in the cold and hardware that shrugs off salt. Those are the qualities we look for when helping you choose, and the ones we install for.
Repairs
The bottom seal, the side and top weatherstrip, and the threshold at the floor are the door's defence against wind, water and snow. Renewing them is quick work and makes a real difference to how the garage feels in January.
Clarington
For an older door in Clarington we look for ways to keep it. Original wood doors and extension-spring setups can run for many more years with safety cables, fresh pulleys and a properly set opener. When a door truly is finished, we say so and explain what a replacement would involve, without pushing.
— Ganaraska Garage Door Pros
Hours
Durham, Ontario
2021 census · what it means at the door
27%Newer homes
About 27% of homes in Clarington were built in 1980 or earlier, according to the 2021 Census.
In newer areas the garage doors along a street often share a style and colour, and homeowners generally want a replacement that blends in. We match panel profiles and finishes closely, or help you choose a deliberate change that still sits comfortably with the neighbours.
78%Mostly houses
Single-detached houses make up about 78% of homes in Clarington (2021 Census).
Detached houses often have a room over the garage, a bedroom or an office, which makes the garage door part of the heated envelope. An insulated door, snug weatherstrip and a fresh bottom seal keep that room comfortable and the furnace from working overtime in winter.
Clarington
Garage Door Bottom Seal Replacement
After a spring rain there is a puddle inside the door that reaches the tires. The driveway slopes toward the garage, the slab has a low corner, and the flattened old seal is not making up the difference.
Garage Door Bottom Seal ReplacementThe technician maps the gap with the door closed, checks the door is level and the bottom section straight, and identifies the retainer and profile. The opener is disconnected and the door clamped at working height. The old seal comes out, the channels are cleaned, a new seal is cut and fed in, and any retainer work is done. The door is then closed under power, the opener reset, and the reversing and photo-eye tests run.
Dry graphite or a PTFE lock lubricant for the key cylinder, because oil traps grit and moisture in the pins. A light silicone film for the bars and their guides, wiped rather than dripping, so salt spray and slush have less to cling to. Grease is avoided everywhere on the lock, as it thickens in the cold and collects dirt that gums the action.
A lift cable does the work: it connects the door's bottom corner to the spring system and carries the door's weight. A safety or containment cable does no lifting at all. It runs through the middle of an extension spring and is anchored at both ends so that if the spring breaks, the pieces stay put. Torsion springs sit on a shaft and do not need one.
Usually a little. A balanced door presents a much lighter load than a door with a broken spring, so the opener's force settings are reset to suit it, and the travel limits are checked so the door seals at the floor and stops cleanly at the top. The technician then runs the reversal test and the photo-eye check to confirm the safety system responds correctly with the new balance.
There is no fixed interval; the door tells you. Many doors go years between adjustments, especially when they are lubricated and the springs were sized correctly. A hand test each season is the reliable guide: if the released door holds at about a metre and stays fully open, it is fine. When it starts to drift or sink, that is the time.
On-site assessment preferred
Book a visit. Talk to a technician.
Open 24/7 · same fees any hour
On-site assessment preferred · (289) 513-6148 · open 24/7
